Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Window Motor Programming - Express Function
If the vehicles battery has been disconnected, each side door window regulator motor must be reprogrammed in order for the express-UP or express-DOWN feature to operate properly. Keep in mind, that if something is obstructing the window from opening or closing and you continue programming, the window will only express-UP or express-DOWN to the spot where the obstruction occurred. If an obstruction comes in contact with the window during the programming procedure, the procedure will have to be repeated.
The following steps explain how to program the side door window regulator motors:
- Press and hold the power window switch until the window is fully DOWN.
- Continue holding the power window switch for approximately 3 seconds.
- Press and hold the power window switch until the window is fully UP.
- Continue holding the power window switch for approximately 3 seconds.
- The power window regulator motor is now programmed for the express function.
- Repeat this process for all of the power windows.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.