Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Hummer H3 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Section 193 (Programming And Setup - All Systems)
WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
- Diagnostic Information and Procedures
- Repair Instructions
- Antenna Module Programming and Setup
- Audio Amplifier Programming and Setup
- Blower Control Module Programming and Setup
- Communication Interface Module Programming and Setup
- Control Solenoid Valve and Transmission Control Module Assembly Programming and Setup
- Cruise Control Module Programming and Setup
- Digital Radio Receiver Programming and Setup
- Door Control Module Programming and Setup
- Electronic Brake Control Module Programming and Setup
- Electronic Suspension Control Module Programming and Setup
- Engine Control Module Programming and Setup (V6)
- Engine Control Module Programming and Setup (with RPO LC3 or LH2)
- Garage Door Opener Programming and Setup
- Head Up Display Programming and Setup
- Headlamp Leveling Module Programming and Setup
- Heated Seat Control Module Programming and Setup
- HVAC Control Module Programming and Setup
- Inflatable Restraint Sensing and Diagnostic Module Programming and Setup
- Inside Rearview Mirror Programming and Setup
- Instrument Cluster Head Up Display Programming and Setup
- Instrument Cluster Programming and Setup
- Instrument Panel Module Programming and Setup
- Memory Seat Control Module Programming and Setup
- Object Alarm Module Programming and Setup
- Passenger Presence System Programming and Setup
- Radio Programming and Setup
- Rear Integration Module Programming and Setup
- Remote Control Door Lock Receiver Programming and Setup (North America and Japan)
- Remote Control Door Lock Receiver Programming and Setup (Europe)
- Seat Climate Control Module Programming and Setup
- Service Programming System (SPS)
- Side Object Sensor Programming and Setup
- Steering Column Lock Control Module Programming and Setup
- Sunroof Control Module Programming and Setup
- Television Antenna Module Programming and Setup
- Vehicle Direction Alert Alarm Warning Module Programming and Setup
- Vehicle Stability Control Module Programming and Setup
- Window Regulator Motor Programming and Setup
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.