2008 Hummer H3 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Fastener Tightening Specifications

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications

Application Specification
Metric English
Antenna Base Screws 7.5 N.m 66 lb in
Cellular And Navigation Antenna Nut 6 N.m 53 lb in
Cellular Communications/Digital Radio Antenna Bolt 6 N.m 53 lb in
Digital Radio Receiver Screws 2 N.m 18 lb in
Front Door Speaker Screws 2.5 N.m 22 lb in
Navigation Control Processor Bracket Nuts 9 N.m 80 lb in
Radio Screws 2 N.m 18 lb in
Rear Door Speaker Screws 2.5 N.m 22 lb in
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.