2008 Hummer H3 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Transfer Case Encoder Motor

Fig 1: Transfer Case Encoder Motor Connector End View
GM646372Courtesy of GENERAL MOTORS CORP.
Transfer Case Encoder Motor

Pin Wire Circuit Function
A 0.5 BK/WH 1554 Low Reference
B 0.5 BN/WH 1555 Channel P Encoder Signal
C 0.5 RD/WH 1556 Channel C Encoder Signal
D 3 BK 1552 Motor Control B
E 3 RD 1553 Motor Control A
F - - Not Used
G 0.5 YE/BK 1558 Channel B Encoder Signal
H 0.5 D-BU/WH 1557 Channel A Encoder Signal
Connector Part Information 
  • OEM: 15326654
  • Service: 88986254
  • Description: 8-Way F GT 280 Series Sealed (BK)
Terminal Part Information 
  • Pins: A-C, G-H
  • Terminal/Tray: 15304719/19
  • Core/Insulation Crimp: E/5
  • Release Tool/Test Probe: 15315247/J-35616-4A (PU)
  • Pins: D-E
  • Terminal/Tray: 15304720/19
  • Core/Insulation Crimp: 4/5
  • Release Tool/Test Probe: 15315247/J-35616-4A (PU)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.