2008 Hummer H3 Adventure, StandardFACTORY OEM SERVICE PROCEDURE

Engine Block - Front View

Fig 1: Engine Block - Front View
GM858387Courtesy of GENERAL MOTORS CORP.
Engine Block - Front View

Service Hole Location Thread Size Drill Counterbore Tool Stop Collar Tap Driver Insert Drill Depth (Max) Tap Depth (Min)
J 42385-400Β  . See Special ToolsΒ . mm (in) mm (in)
1 M 6 x 1 405 n/a 407 203 204 205 30 1.182 26 1.024
2 M 6 x 1 201 202 n/a 203 204 205 18 0.709 14 0.551
3 M 6 x 1 201 202 n/a 203 204 205 22 0.866 18 0.709
4 M 8 x 1.25 206 207 n/a 208 209 210 23 0.906 18 0.709
5 M 16 x 1.5 405 n/a 407 203 204 205 24 0.945 16 0.630
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.