Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Hummer H3 L5-3.7LFACTORY OEM SERVICE PROCEDURE
Timing Chain Guide Replacement - Upper
Timing Chain Guide Replacement - Upper
Removal Procedure
1. Remove the camshaft cover.
2. Remove the upper timing chain guide bolts.
3. Remove the upper timing chain guide from the cylinder head.
Installation Procedure
1. Position the upper timing chain guide to the cylinder head.
2. Apply threadlock to the upper timing chain guide bolt threads.
Notice: Refer to Fastener Notice.
3. Install the upper timing chain guide bolts.
Tighten the bolts to 10 N.m (89 lb in).
4. Install the camshaft cover.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
