Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Hummer H3 AutomaticFACTORY OEM SERVICE PROCEDURE
Section 12 (Interior Trim)
WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Repair Instructions
- Eliminating Unwanted Odors in Vehicles
- Door Sill Plate Replacement - Front
- Door Sill Plate Replacement - Rear
- Floor Carpet Drying
- Carpet Replacement
- Headliner Replacement (Crew Cab)
- Headliner Replacement (Extended Cab)
- Headliner Replacement (Regular Cab)
- Assist Handle Replacement
- Coat Hook Replacement
- Sunshade Replacement
- Garnish Molding Replacement - Windshield Pillar
- Trim Panel Replacement - Left Hinge Pillar
- Trim Panel Replacement - Right Hinge Pillar
- Trim Panel Replacement - Upper Center Pillar
- Trim Panel Replacement - Lower Center Pillar
- Trim Panel Replacement - Body Rear Corner - Upper (Regular Cab, Extended Cab)
- Trim Panel Replacement - Body Rear Corner - Upper (Crew Cab)
- Trim Panel Replacement - Body Rear Corner - Lower (Crew Cab)
- Trim Panel Replacement - Body Rear Corner - Lower (Regular Cab)
- Trim Panel Replacement - Body Rear Corner - Lower (Extended Cab)
- Trim Panel Replacement - Body Rear (Regular Cab)
- Trim Panel Replacement - Body Rear (Extended Cab)
- Trim Panel Replacement - Body Rear (Crew Cab)
- Cover Replacement - Jack Stowage
- Jack and Tool Stowage Container Bracket Replacement
- Storage Compartment Replacement - Rear
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
