2007 Hummer H3 AutomaticFACTORY OEM SERVICE PROCEDURE

Circuit/System Testing

  1. Verify that the transmitter being used is a correct P/N transmitter for the vehicle.
    • If not the correct transmitter, replace the transmitter.
  2. Using the J 43241Β  , place the keyless entry transmitter on the test pad and press each transmitter button one at a time. The green light on the tester should illuminate and a tone should sound with each button press.
    • If no tone or illumination occurs with any of the buttons, replace the transmitter battery and retest the transmitter.
    • If no tone or illumination occurs with one or more, but not all, buttons, replace the transmitter.
  3. Ignition ON, verify the scan tool No. of Fob's Programmed parameter is Fob 1, Fob 2, Fob 3 or Fob 4.
    • If not the specified value, reprogram the keyless entry transmitters. Refer to Transmitter ProgrammingΒ . If the keyless entry transmitters will not program, replace the BCM.
  4. If all circuits test normal, replace the BCM.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.