Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Hummer H2 V8-6.0LFACTORY OEM SERVICE PROCEDURE
Power Window Switch: Locations
Window Systems Component Views
Instrument Panel
1 - Speaker - LF Tweeter
2 - Instrument Cluster
3 - Turn Signal/Multifunction Switch
4 - Traction Control Switch
5 - Radio
6 - HVAC Control Module
7 - Speaker - RF Tweeter
8 - Inflatable Restraint I/P Module
9 - Inflatable Restraint I/P Module Disable Switch
10 - Digital Radio Receiver
11 - Ride Height Switch (ZM6)
12 - Tow/Haul Switch
13 - Headlamp and Panel Dimmer Switch
14 - Midgate Window Switch (SUT) or Rear Wiper/Washer Switch (Except SUT)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
