Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Hummer H2 V8-6.0LFACTORY OEM SERVICE PROCEDURE
Keyless Entry Transmitter Battery: Service and Repair
Transmitter Battery Replacement
Removal Procedure
Under normal use, the battery in the transmitter will last about 2 years, form battery replacement, use a Panasonic 3 volt, type CR2032, or the equivalent.
1. In order to open the transmitter case, perform the following steps:
1. Insert a dime between the two halves of the transmitter near the key ring hole.
2. Twist the dime.
2. Remove the battery.
Installation Procedure
1. Install the battery with the (+) side down.
2. In order to close the transmitter case, perform the following steps:
1. Align the top and bottom covers.
2. Snap together the top and bottom covers.
3. Inspect the operation of the transmitter.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.