2007 Hummer H2 4D Utility PickupFACTORY OEM SERVICE PROCEDURE

Control Units

CONTROL UNITS LOCATION

Component Location
Air Suspension Module Near left side of compressor.
Blower Motor Control Processor Behind right side of dash, on HVAC assembly. See Figure.
Body Control Module (BCM) On top left side of dash, above I/P fuse block. See Figure.
Driver Door Module (DDM) Behind driver's door panel. See Figure.
Electronic Brake Control Module (ECBM) On left side of inner frame. See Figure.
Heated Seat Control Module-LR Under left side of 2nd row seat. See Figure.
Heated Seat Control Module-RR Under right side of 2nd row seat. See Figure.
HVAC Control Module Center of dash. See Figure.
HVAC Module On HVAC assembly. See Figure.
Inflatable Restraint I/P Module Behind right side of dash. See Figure.
Inflatable Restraint I/P Module Connector Behind right side of dash. See Figure.
Inflatable Restraint Sensing & Diagnostic Module (SDM) Under left front seat. See Figure.
Inflatable Restraint Sensing & Diagnostic Module (SDM) Connector Under left front seat. See Figure.
Inflatable Restraint Steering Wheel Module Under horn pad. See Figure.
Memory Seat Module Under driver seat. See Figure.
Midgate Control Module Center of midgate assembly, attached to window regulator assembly.
Passenger Door Module (PDM) In passenger door. See Figure.
Powertrain Control Module (PCM) On left front of engine compartment. See Figure.
Rear Window Wiper/Washer Module At center of liftgate. See Figure.
RSA Controller At rear of center console. See Figure.
Sunroof Module In front of headliner, near front overhead console. See Figure.
Throttle Actuator Control (TAC) Module At left rear of engine compartment. See Figure.
Transfer Case Shift Control Module Behind headlight switch. See Figure.
Vehicle Communication Interface Module At center of dash, below HVAC control module. See Figure.
Windshield Wiper/Washer Module Under windshield cowl, between wiper arms. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.