Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Hummer H2 4D Utility PickupFACTORY OEM SERVICE PROCEDURE
Installation Procedure
- Connect the pump motor connector (3) to the bottom of the EBCM.
- Install the EBCM (1) to the BPMV (4).
- Install the 6 retainers (2) which connect the EBCM to the BPMV.
Tighten: Tighten the retainers to 2.9 N.m (26 lb in).
- Connect the EBCM harness connector.
- Lower the vehicle.
- Turn the ignition switch to the RUN position. Do NOT start the engine.
- Perform the diagnostic system check. Refer to Diagnostic System Check - Vehicle .
- Refer to Control Module References for programming and setup information.
NOTE:
Refer to Fastener Notice
.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.