2006 Hummer H3 L5-3.5LFACTORY OEM SERVICE PROCEDURE

Ignition Coil: Service and Repair



IGNITION COIL(S) REPLACEMENT

REMOVAL PROCEDURE
1. Remove the air cleaner resonator and outlet duct.

Factory service manual diagram



2. Disconnect the engine wiring harness electrical connector (1) from the oil pressure sensor (2).

Factory service manual diagram



3. Disconnect the engine wiring harness retainers (1) from the power steering pump (2).

Factory service manual diagram



4. Disconnect the engine wiring harness electrical connectors (1, 4) from the following:
- The exhaust camshaft position (CMP) sensor (5)
- The camshaft position (CMP) actuator solenoid valve (6)
5. Disconnect the engine wiring harness retainer (2) from the camshaft cover (3).

Factory service manual diagram



6. Disconnect the engine wiring harness electrical connectors from the following:
- The engine coolant temperature (ECT) sensor (1)
- The fuel injector harness (2)
- The ignition coils (4)
- The heated oxygen sensor (HO2S) (5)

Factory service manual diagram



7. Disconnect the engine wiring harness electrical connector from the intake camshaft position (CMP) sensor.

Factory service manual diagram



8. Carefully disengage the engine wiring harness conduit from the camshaft cover, and position aside.

Factory service manual diagram



9. Remove the ignition coil bolts.
10. Remove the ignition coils from the camshaft cover.

INSTALLATION PROCEDURE

Factory service manual diagram



1. Install the ignition coils into the camshaft cover.

IMPORTANT: Ensure the ignition coil seals are properly seated to the camshaft cover.

2. Install the ignition coil bolts.

Tighten the bolts to 10 N.m (89 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

Factory service manual diagram



3. Attach the engine wiring harness conduit to the camshaft cover.

Factory service manual diagram



4. Connect the engine wiring harness electrical connector to the intake CMP sensor.

Factory service manual diagram



5. Connect the engine wiring harness electrical connectors to the following:
- The ECT sensor (1)
- The fuel injector harness (2)
- The ignition coils (4)
- The HO2S (5)

Factory service manual diagram



6. Connect the engine wiring harness electrical connectors (1, 4) to the following:
- The exhaust CMP sensor (5)
- The CMP actuator solenoid valve (6)
7. Connect the engine wiring harness retainer (2) to the camshaft cover (3).

Factory service manual diagram



8. Connect the engine wiring harness retainers (1) to the power steering pump (2).

Factory service manual diagram



9. Connect the engine wiring harness electrical connector (1) to the oil pressure sensor (2).
10. Install the air cleaner resonator and outlet duct.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.