2006 Hummer H3 AutomaticFACTORY OEM SERVICE PROCEDURE

Removal Procedure

    Fig 1: View Of Intake CMP Sensor Engine Wiring Harness Connector
    GM1350719Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the engine wiring harness electrical connector from the intake camshaft position (CMP) sensor.
  2. Fig 2: View Of Intake Camshaft Sensor
    GM858173Courtesy of GENERAL MOTORS CORP.
  3. Remove the intake CMP sensor retaining bolt.
  4. Remove the intake CMP sensor from the cylinder head.

    Discard the O-ring seal.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.