2006 Hummer H3 AutomaticFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: Starter Wiring
    GM1560044Courtesy of GENERAL MOTORS CORP.
  1. Insert the generator positive cable into the battery cables harness conduit.
  2. Install the positive cable clip (3) to the engine wiring harness bracket.
  3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Connect the generator positive lead (2) to the generator and install the generator output BAT terminal nut (1).

    Tighten:Β  Tighten the nut to 20 N.m (15 lb ft).

  5. Position the protective boot onto the generator output BAT terminal.
  6. Fig 2: Nuts Securing The Battery Cables To Underhood Fuse Block
    GM1560045Courtesy of GENERAL MOTORS CORP.
  7. Install the nut (1) securing the generator positive cable inner terminal to the underhood fuse block.

    Tighten:Β  Tighten the nut to 9 N.m (80 lb in).

  8. Install the underhood fuse block cover to the underhood fuse block, engaging the locking tabs.
  9. Fig 3: Harness Clips
    GM1560042Courtesy of GENERAL MOTORS CORP.
  10. Install the battery cable harness clips (1, 2) to the battery tray.
  11. Connect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect ProcedureΒ .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.