Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Hummer H2 V8-6.0LFACTORY OEM SERVICE PROCEDURE
Window Channel Replacement - Midgate
Window Channel Replacement - Midgate
Removal Procedure
1. Remove the midgate inner panel. Refer toMidgate Panel Replacement - Inner () .
2. Remove the midgate window. Refer to Window Replacement - Midgate (Service and Repair) .
3. Remove the screws retaining the midgate window run channels.
4. Disconnect the electrical connectors.
5. Remove the wiring harness retainer from the window run channel brackets.
6. Remove the window run channels from the midgate.
Installation Procedure
1. Install the midgate window run channels to the midgate.
2. Loosely install the screws retaining the midgate window run channels to the midgate.
3. Install the wiring harness retainer to the window run channel bracket.
4. Install the midgate window. Refer to Window Replacement - Midgate (Service and Repair) .
5. Connect the electrical connectors.
Notice: Refer to Fastener Notice in Cautions and Notices.
6. Finish tightening the screws retaining the window run channels to the midgate.
Tighten the screws to 10 Nm (89 lb in).
7. Adjust the midgate window, if necessary. Refer to Window Adjustment - Midgate (Adjustments) .
8. Install the midgate inner panel. Refer toMidgate Panel Replacement - Inner () .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
