Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2004 Hummer H2 4D Utility PickupFACTORY OEM SERVICE PROCEDURE

Removal Procedure

Fig 1: Removing & Installing Console

Courtesy of GENERAL MOTORS CORP.

Remove the console. Refer to Console Replacement in Instrument Panel, Gauges and Console.

Fig 2: Shift Lock Actuator & Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Disconnect the Shift Lock Actuator electrical connector (3).
Remove the Shift Lock Actuator fasteners and remove Actuator (2).

Chapter Navigation

Return to Chapter: Automatic Transmission Shift Lock Actuator Replacement

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.