2004 Hummer H2 4D Utility PickupFACTORY OEM SERVICE PROCEDURE

Control Units

CONTROL UNITS LOCATION

Component Location
Air Suspension Module Near right front of compressor. See Figure .
Blower Motor Control Processor Behind right side of dash, on HVAC assembly. See Figure .
Body Control Module (BCM) On top left side of dash, above I/P fuse block. See Figure .
Driver Door Module (DDM) In driver's door, part of switch assembly. See Figure .
Electronic Brake Control Module (ECBM) On left side of inner frame. See Figure .
FLASHER MODULE On back side of I/P fuse block. See Figure .
Heated Seat Control Module-LR Under left side of 2nd row seat. See Figure .
Heated Seat Control Module-RR Under right side of 2nd row seat. See Figure .
HVAC Control Module Behind center of dash. See Figure .
HVAC Module On HVAC assembly. See Figure .
Inflatable Restraint I/P Module Behind right side of dash. See Figure .
Inflatable Restraint I/P Module Connector Behind right side of dash. See Figure .
Inflatable Restraint Sensing & Diagnostic Module (SDM) Under left front seat. See Figure .
Inflatable Restraint Sensing & Diagnostic Module (SDM) Connector Under left front seat. See Figure .
Inflatable Restraint Steering Wheel Module Under horn pad. See Figure .
Memory Seat Module (Driver) Under driver seat. See Figure .
Passenger Door Module (PDM) In passenger door. See Figure .
Powertrain Control Module (PCM) On left front of engine compartment. See Figure .
Rear Window Wiper Module - W/Motor At center of liftgate. See Figure .
RSA Controller At rear of center console. See Figure .
Sunroof Module In front of headliner, near front overhead console. See Figure .
Theft Deterrent Control Module In steering column.
Throttle Actuator Control (TAC) Module At left rear of engine compartment. See Figure .
Transfer Case Shift Control Module Behind headlamp switch. See Figure .
Vehicle Communication Interface Module At center of dash, below HVAC control module. See Figure .
Windshield Wiper/Washer Module Under windshield cowl, between wiper arms. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.