2004 Hummer H2 4D Utility PickupFACTORY OEM SERVICE PROCEDURE

Tools Required

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  • J 42385-600Β  Thread Repair Kit
  • J 42385-300Β  Fixtures and Hardware Kit
  1. The main cap bolt hole thread repair kit J 42385-600Β  and J 42385-300Β  consists of the following items:
    • Drill (1)
    • Tap (2)
    • Installer (3)
    • Fixture plate (4)
    • Long bolts (5)
    • Short bolts (6)
    • Alignment pin (7)
    • Bushing (8)
    Fig 1: Identifying Main Cap Bolt Hole Thread Tools
    G01815373Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.