2003 Hummer H2FACTORY OEM SERVICE PROCEDURE

Fastener Tightening Specifications

Fastener Tightening Specifications

Application Specification
Metric English
Horn Contact Plate Screws 5.5 N.m 49 lb in
Ignition Lock Cylinder Case Screws 7 N.m 62 lb in
Intermediate Shaft to the Steering Column Pinch Bolt 62 N.m 46 lb ft
Intermediate Shaft to the Steering Gear Pinch Bolt 47 N.m 35 lb ft
Steering Column Electrical Connector Screw 6 N.m 53 lb in
Steering Column Mounting Nuts 27 N.m 20 lb ft
Steering Column Trim Cover Screws Lower 3.5 N.m 31 lb in
Steering Column Trim Cover Screws Upper 1 N.m 9 lb in
Steering Wheel Nut 41 N.m 30 lb ft
Steering Wheel Shroud Retaining Screws 2 N.m 18 lb in
Turn Signal Multifunction Switch Screws Side 7 N.m 62 lb in
Turn Signal Multifunction Switch Screws Top 3 N.m 27 lb in
Upper Intermediate Shaft to Lower Intermediate Shaft Pinch Bolt 50 N.m 37 lb ft
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.