Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2003 Hummer H2FACTORY OEM SERVICE PROCEDURE

Removal Procedure

Remove the steering wheel. Refer to Steering Wheel Replacement .

Fig 1: View Of Shroud & Screws

Courtesy of GENERAL MOTORS CORP.

Remove the shroud retaining screws from the back of the steering wheel.
Remove the shroud from the steering wheel.

Fig 2: Locating Wire Harness Cavity

Courtesy of GENERAL MOTORS CORP.

Position a blunt ended tool into the wire harness cavity (1) and apply moderate pressure in order to partially remove the steering wheel control switch from the steering wheel.

Fig 3: View Of Steering Wheel Control Switch Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Disconnect the steering wheel control switch electrical connector.

IMPORTANT: The bulbs in the steering wheel control switches are not serviceable. The switches should be replaced only as an assembly.

Remove the steering wheel control switch from the steering wheel.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.