Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Hummer H2FACTORY OEM SERVICE PROCEDURE
Installation Procedure
- Install the steering column to the vehicle and connect the column to the intermediate shaft.
- Install the steering column mounting nuts.
Tighten:Β Tighten the nuts to 27 N.m (20 lb ft).
- Install the intermediate shaft bolt to the steering column.
Tighten:Β Tighten the bolt to 50 N.m (37 lb ft).
- Connect the wiring harness connector to the back of the fuse block.
- Connect the steering column electrical connector to the body wiring harness.
- Reposition the transfer case electronic control module bracket and install the bolts.
Tighten:Β Tighten the bolts to 2 N.m (18 lb in).
- Install the transfer case electronic control module. Refer to Transfer Case Shift Control Module Replacement .
- Connect the HVAC duct (3).
- Install the knee bolster deflector. Refer to Bracket Replacement - Steering Column .
- Unlock the steering column by removing J 42640Β from the lower trim cover access hole.
- Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 .
NOTE:
Refer to Fastener Notice
.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
