2003 Hummer H2FACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Motors

MOTORS LOCATION

Component Location
Air Temperature Actuator (Left) Attached to lower middle underside of HVAC assembly, below evaporator. See Figure .
Air Temperature Actuator (Right) At middle top of HVAC assembly, above evaporator. See Figure .
Blower Motor At right lower side of dash, on HVAC assembly.
Fuel Pump & Sender Assembly In fuel tank. See Figure .
Mode Actuator On left side of HVAC assembly. See Figure .
Recirculation Actuator On top front of HVAC assembly. See Figure .
Throttle Actuator Control Assembly Mounted to throttle body assembly, on top of engine.
Throttle Actuator Control Motor Mounted to throttle body assembly, on top of engine.
Windshield Washer Fluid Pump (Reversible) In washer fluid reservoir.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.