Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Hummer H2FACTORY OEM SERVICE PROCEDURE
Suspension, Electronic DTCS
SUSPENSION, ELECTRONIC AIR BAG DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description |
|---|---|
| DTC B2795 | Ride Height Switch Signal Circuit Voltage Is Shorted To Ground Or Battery |
| DTC C0563 | EEPROM |
| DTC C0569 | Height Sensor Voltage |
| DTC C0626 | Suspension Sensor Voltage |
| DTC C0631 | Suspension Sensor Voltage |
| DTC C0660 | Exhaust Valve Voltage |
| DTC C0696 | Air Suspension Sensors Or Air Suspension Pressure Sensor Current Draw |
| DTC C0702 | General Valve Voltage |
| DTC C0707 | Compressor Run Time Exceeded |
| DTC C0711 | Rate Of Height Change, Central Air Camber Pressure Or Air Pressure Sensor Signal Is Out Of Limits |
| DTC C0712 | Relay Circuit Voltage |
| DTC C0713 | Compressor Overtemperature Or Loss Of Ground At Module Pin 18 |
| DTC C0716 | Inlet Valve Voltage |
| DTC C0717 | Inlet Valve Voltage |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
