Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Hummer H2FACTORY OEM SERVICE PROCEDURE
Air Bag DTCS
AIR BAG DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description |
|---|---|
| DTC B0016, B0017, or B0018 | I/P Module Deployment Loop |
| DTC B0022, B0024, or B0026 | Steering Wheel Module Deployment Loop |
| DTC B0051 | Commanded Air Bag Deployment With No Faults Present |
| DTC B0053 | Deployment Occurs With Inflator Circuit Fault |
| DTC B0090 | Module Suppression Indicator Control Is Low Or High |
| DTC B0091 | I/P Module Disable Switch |
| DTC B0100, B0101, B0102, B0103, B0104, or B0105 | Electronic Frontal Sensor |
| DTC B1001 | Restraints ID |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
