2003 Hummer H2FACTORY OEM SERVICE PROCEDURE

Class 2 Serial Data Link

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.

Scan tool will power up with ignition switch in OFF position. Some modules will not communicate unless ignition switch is in RUN position and Power Mode Master (PMM) module (DIM) sends appropriate power mode message. Data link is configured as a ring with discrete lines entering and leaving each module. This allows communication with modules on ring if one of two discrete circuits is open. Modules on data link include:

  • Driver Door Module (DDM)
  • Dash Integration Module (DIM)
  • Driver Information Center (DIC)
  • Electronic Brake Control Module (EBCM)
  • Instrument Panel Cluster (IPC)
  • Instrument Panel Module (IPM)
  • Memory Seat Module (MSM)
  • Powertrain Control Module (PCM)
  • Radio
  • Rear Integration Module (RIM)
  • Remote Control Door Lock Receiver (RCDLR)
  • Sensing & Diagnostic Module (SDM)
  • CD Changer
  • Theft Deterrent Control (TDC) Module
  • Vehicle Communication Interface Unit (VCIM)
  • Vehicle Interface Unit (VIU)
DDM, MSM, VCIU and VIU have only one connection to data link wiring.

Power door serial data circuit does not communicate with scan tool via DLC. Power door serial data information is interpreted by Driver Door Module (DDM) and transmitted on Class 2 data link by DDM. Door system serial data circuit is used for serial data communication between each door module and driver door switch assembly (DDSA).

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.