2003 Hummer H2FACTORY OEM SERVICE PROCEDURE

Removal Procedure

WARNING: This page is about a different car, the 2004 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON position.
  1. Turn the ignition switch to the OFF position.
  2. Raise the Vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Disconnect the EBCM harness connector.
  4. Remove any dirt/debris from the assembly.
  5. Fig 1: EBCM & BPMV
    GM213438Courtesy of GENERAL MOTORS CORP.
  6. Remove the 6 retainers (2) that connect the EBCM to the BPMV.
  7. IMPORTANT: Do not pry apart using a tool. Be careful not to damage the BPMV surface.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.