2003 Hummer H2FACTORY OEM SERVICE PROCEDURE

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to FASTENER NOTICE .
  1. Install the lateral accelerometer (2).
    Fig 1: Installing Lateral Accelerometer
    G01420484Courtesy of GENERAL MOTORS CORP.

    Tighten 

    Tighten the two lateral accelerometer nuts (1) to 3 N.m (24 lb in).

  2. Connect the lateral accelerometer connector.
  3. Install the passenger seat. Refer to SEAT REPLACEMENT (POWER) or SEAT REPLACEMENT (MANUAL) in Seats.
  4. Turn the ignition switch to the ON position, engine off.
  5. Perform the DIAGNOSTIC SYSTEM CHECK - ABS  .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.