Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection/Maintenance Complete System Set Procedure: Description
The purpose of I/M Complete System Set Procedure is to satisfy the enable criteria necessary to execute all I/M readiness diagnostics, and complete the trips for those particular diagnostics. When all diagnostic tests are completed, I/M SYSTEM STATUS indicators are set to YES. Perform this test when more than one or all I/M System Status indicators are set to NO.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.