2003 Hummer H2FACTORY OEM SERVICE PROCEDURE

Service Specifications

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
A/C SYSTEM SPECIFICATIONS

Application Specification
Compressor Type ATMOS GU10
Compressor Magnetic Clutch Air Gap 0.014-0.029" (0.35-0.75 mm)
Compressor Oil Capacity 5.24 Ozs.
Magnetic Clutch Gap 0.012-0.019" (0.30-0.50 mm)
Pressure Relief Valve (1)
Refrigerant (R-134a) Capacity 16.8-18.5 ozs.
Refrigerant Pressure Switch
On
Low Side 25.53-36.31 psi (176-250 kPa)
High Side 57-114 psi (393-786 kPa)
Off
Low Side 25.53-31.31 psi (176-216 kPa)
High Side 427-463 psi (2944-3192 kPa)
System Oil Capacity (1)
System Operating Pressures (2)
High Side 180-264 psi (1241-1820 kPa)
Low Side 12-23 psi (83-159 kPa)
(1) Information not available from manufacturer.
(2) Specification is with ambient temperature at 86Β°F (30Β°C) and engine speed at 1500 RPM. Specifications are approximate.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.