2003 Hummer H2FACTORY OEM SERVICE PROCEDURE

Evaporator Temperature Sensor Inspection

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Inspect the evaporator temperature sensor when it is installed to the A/C unit.
  1. Set the fan speed MAX HI.
  2. Set the temperature control at MAX COLD.
  3. Set the RECIRCULATE mode.
  4. Turn the A/C switch off.
  5. Close all doors and windows.
  6. Wait for 5 min.Β 
  7. Disconnect the evaporator temperature sensor connector.
  8. Measure the temperature at the blower inlet.
  9. Measure the resistance between the evaporator temperature sensor terminals.
    • If the resistance is not as shown in the graph, replace the evaporator temperature sensor.
    Fig 1: Resistance Vs Temperature Graph
    G00975604Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.