2003 Hummer H2FACTORY OEM SERVICE PROCEDURE

Component Locations

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
COMPONENT LOCATIONS

Component Location
Driver-side air bag module On steering wheel
Knee bolsters Driver-side & passenger-side lower instrument panel
Passenger-side air bag module Passenger-side instrument panel
Passenger-side air bag module disable switch Inside glove box
Passenger-side air bag module disable switch indicator In center console
Sensing & Diagnostic Module (SDM) Under center of instrument panel
SIR coil Below steering wheel
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.