2003 Hummer H2FACTORY OEM SERVICE PROCEDURE

Component Locations

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
COMPONENT LOCATIONS

Component Location
AIR BAG warning light Instrument Panel Cluster (IPC)
Driver-side air bag module On steering wheel
Electronic Frontal Sensors (EFS) Lower frame rail
Passenger Presence Detection (PPD) switch Under passenger front seat
Passenger-side air bag module Passenger-side of instrument panel
Passenger-side air bag module disable switch Center of instrument panel
Seat Position Sensors (SPS) Under driver and front passenger seat
Sensing & Diagnostic Module (SDM) Under driver seat
SIR coil assembly Under steering wheel
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.