2003 Hummer H2FACTORY OEM SERVICE PROCEDURE

Fuel Pump

FUEL PUMP PERFORMANCE

Application psi (kPa)
Bi-Fuel Engines (1) (2) 130-200 (826-1379)
CNG Engines (3) 110-210 (758-1448)
Gasoline Engines 55-62 (379.2-427.5)
(1) Bi-fuel engines are equipped with a gasoline and a CNG injector on each cylinder.
(2) Pressure reading as shown under FRP display on a scan tool.
(3) Pressure checked at Intermediate Pressure Regulator (IPR) test port using CNG Electronic Pressure Gauge Kit (J-39970).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.