2003 Hummer H2FACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: Identifying Brake/Hub Components
    GM379487Courtesy of GENERAL MOTORS CORP.
  1. Install the WSS (5) into the hub/bearing assembly (4).
  2. NOTE: Refer to Fastener Notice .
  3. Install the WSS mounting bolt.

    Tighten:Β  Tighten the WSS mounting bolt to 18 N.m (13 lb ft).

  4. Fig 2: View Of Wheel Speed Sensor Cable And Connectors
    GM913362Courtesy of GENERAL MOTORS CORP.
  5. Install the WSS cable mounting clip to the knuckle.
  6. Install the WSS cable mounting clip to the upper control arm.
  7. Install the WSS cable mounting clip to the frame attachment point.
  8. Connect the WSS cable electrical connector.
  9. Install the brake rotor. Refer to Brake Rotor - Front .
  10. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  11. Return to Diagnostic Starting Point - Antilock Brake SystemΒ .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.