2003 Hummer H2FACTORY OEM SERVICE PROCEDURE

Inflatable Restraint I/P Module Disable Switch Connector End View

Inflatable Restraint I/P Module Disable Switch

GM362753Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 15305286
  • 6-Way F Metri-Pack 150 Series (YEL)
Pin Wire Color Circuit No. Function
A TAN/BLK 371 I/P Module Disable Switch - Signal
B YEL 1139 Ignition 1 Voltage
C BRN 2409 Interior Park Lamps Supply Voltage
D BRN/WHT 230 Instrument Panel Lamps Dimming Control
E PNK 353 I/P Module Suppression Indicator Control
F BLK 1050 Ground
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.