2003 Hummer H2 V8-6.0LFACTORY OEM SERVICE PROCEDURE

Generator Replacement

GENERATOR REPLACEMENT

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

Factory service manual diagram



1. Disconnect the negative battery cable.
2. Remove the accessory drive belt.
3. Remove the engine sight shield.
4. Disconnect the generator electrical connector.

Factory service manual diagram



5. Remove the generator cable from the generator, perform the following:
5.1. Slide the boot down revealing the terminal stud.
5.2. Remove the generator cable nut from the terminal stud.
5.3. Remove the generator cable.

Factory service manual diagram



6. Remove the generator bolts.
7. Remove the generator.

INSTALLATION PROCEDURE

Factory service manual diagram



1. Install the generator.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the generator bolts.

Tighten
Tighten the generator bolts to 50 N.m (37 lb ft).

Factory service manual diagram



3. Install the generator cable to the generator, perform the following:
3.1. Install the generator cable.
3.2. Install the generator cable nut to the terminal stud.

Tighten
Tighten the generator cable nut to 9 N.m (80 lb in).

3.3. Slide the boot over the terminal stud.

Factory service manual diagram



4. Connect the generator electrical connector (3).
5. Install the engine sight shield.
6. Install the accessory drive belt.

Factory service manual diagram



7. Connect the negative battery cable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.