Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Hummer H2 V8-6.0LFACTORY OEM SERVICE PROCEDURE
Spark Plug: Specifications
Spark Plug Gap 1.02 mm (0.040 in.)
Spark Plug Torque
Used Heads 15.0 Nm (11.0 lb. ft.)
New Aluminum Heads 20 Nm (15 lb ft.)
New Iron Heads 30 Nm (22 lb ft.)
Spark Plug Torque
Used Heads 15.0 Nm (11.0 lb. ft.)
New Aluminum Heads 20 Nm (15 lb ft.)
New Iron Heads 30 Nm (22 lb ft.)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.