Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Hummer H2 V8-6.0LFACTORY OEM SERVICE PROCEDURE
Knock Sensor: Service and Repair
KNOCK SENSOR (KS) REPLACEMENT
REMOVAL PROCEDURE
1. Remove the intake manifold.
2. Remove the knock sensor wiring harness assembly.
3. Remove the knock sensor (KS).
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the knock sensor.
Tighten
Torque the sensor to 20 N.m (15 lb ft).
2. Install the knock sensor wiring harness assembly.
3. Install the intake manifold.
REMOVAL PROCEDURE
1. Remove the intake manifold.
2. Remove the knock sensor wiring harness assembly.
3. Remove the knock sensor (KS).
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the knock sensor.
Tighten
Torque the sensor to 20 N.m (15 lb ft).
2. Install the knock sensor wiring harness assembly.
3. Install the intake manifold.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.