2024 Honda Pilot EX-L, AWDFACTORY OEM SERVICE PROCEDURE

Quick Lookups: Fluids

FLUID CAPACITIES
Fluid Type Application Standard Metric Fluid Spec Note S/H
Air Cond Compressor Oil N/A N/A RB100EV-01 (POE) Capacity is between: 4.29 - 5.17 ozs. S
Air Cond Refrigerant N/A N/A HFO-1234yf (R-1234yf) Capacity is between: 1.11 - 1.23 lbs. S
Automatic Transmission Fluid AWD 4.40 QTS. 4.16 L HONDA Automatic Transmission Fluid ATF-TYPE 2.0 S
Brake Fluid N/A N/A HONDA Heavy Duty Brake Fluid DOT 3 If DOT 3 Brake Fluid is not available, then DOT 4 or DOT4+ is acceptable. Brake fluid marked DOT 5 is not compatible with your vehicle’s braking system and can cause extensive damage. S
Differential Gear Oil Rear 1.76 QTS. 1.66 L HONDA DPSF-II S
Engine Coolant 8.13 QTS. 7.69 L HONDA Long-Life Antifreeze/Coolant Type 2 This coolant is pre-mixed with 50/50 antifreeze and water. Never add straight antifreeze or plain water. S
Engine Oil Drain and Refill,w/Filter 5.80 QTS. 5.48 L Genuine HONDA Motor Oil 0W-20 or API service SN or higher grade SAE 0W-20 You may also use synthetic motor oil if it is labeled with the API Certification Seal and is the specified viscosity grade. S
Engine Oil Drain and Refill,w/o Filter 5.50 QTS. 5.2 L Genuine HONDA Motor Oil 0W-20 or API service SN or higher grade SAE 0W-20 You may also use synthetic motor oil if it is labeled with the API Certification Seal and is the specified viscosity grade. S
Fuel Tank 18.50 GALS. 70.03 L S
Transfer Case Fluid 0.58 QTS. 0.54 L HONDA Hypoid Gear Oil HGO-1. API GL 4 or GL 5, SAE 75W-85 Hypoid Gear Oil (SAE 90 can be used). S
Windshield Washer Fluid w/o Surround Camera System 2.60 QTS. 2.46 L All Weather Windshield Washer Fluid DO NOT use engine antifreeze or a vinegar/water solution in the windshield washer reservoir. S
Windshield Washer Fluid w/Surround Camera System 4.80 QTS. 4.54 L All Weather Windshield Washer Fluid DO NOT use engine antifreeze or a vinegar/water solution in the windshield washer reservoir. S
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.