Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Honda Ridgeline RTL, FWDFACTORY OEM SERVICE PROCEDURE
Multiplex Integrated Control Unit (MICU) DTCS: 2020
| DTC | Description |
|---|---|
| B1002 | MICU internal error (EEPROM error) |
| B1003 | MICU update error |
| B1036 | IG1 power supply circuit malfunction |
| B1077 | Windshield wiper motor (Park) signal error |
| B1081 | Left side LED headlight malfunction |
| B1082 | Left side LED headlight circuit malfunction |
| B1083 | Right side LED headlight malfunction |
| B1084 | Right side LED headlight circuit malfunction |
| B1275 | Headlight OFF position circuit malfunction |
| B1276 | Headlight switch parking (small) position circuit malfunction |
| B1277 | Headlight AUTO position circuit malfunction |
| B1278 | Headlight ON position circuit malfunction |
| B1279 | Dimmer switch circuit malfunction |
| B1280 | Turn signal switch circuit malfunction |
| B1281 | Front wiper MIST position circuit malfunction |
| B1282 | Front wiper INT (AUTO) position circuit malfunction |
| B1283 | Front wiper LOW position circuit malfunction |
| DTC | Description |
|---|---|
| B1284 | Front wiper HIGH position circuit malfunction |
| U0199 | MICU lost communication with power window master switch |
| U1280 | B-CAN communication bus line error (BUS-OFF) |
| U128D | MICU lost communication with gauge control module |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
