2021 Honda Pilot EliteFACTORY OEM SERVICE PROCEDURE

Auto Idle Stop (2016 2017 2018): Overview

Auto idle stop system is a system that stops an engine (warmed-up condition) when a vehicle stops, and it is determined by the driver's operation, the environment in the cabin and outside of the vehicle, the condition of the vehicle. The auto idle stop system can improve the fuel efficiency and reduce the idling noise. The auto idle stop system and active control engine mount (ACM) system are performed coordinated control, in order to reduce the vibration when the engine restarts. The auto idle stop is enabled when pressing the brake pedal with the vehicle stop. During idling stops, the auto idle stop indicator (green) is indicated on the gauge control module.

Restarts the engine automatically after releasing the brake pedal, and also automatically restarts the engine by the driver operations, environments of the cabin/outside of the vehicle, and the vehicle conditions without releasing the brake pedal.

GHH308281Courtesy of HONDA, U.S.A., INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.