2021 Honda Passport EX-L, AWDFACTORY OEM SERVICE PROCEDURE

Tailpipe Emissions Test: Test

  1. HDS - ConnectΒ 
  2. Tailpipe Emissions - Test
    1. Start the engine. Hold the engine speed at 3, 000 rpm without load (in P or N) until the radiator fan comes on, then let it idle.

    2. Check the idle speed within specificationΒ 

    3. Warm up and calibrate the CO meter according to the meter manufacturer's instructions.

    4. Check idle CO with the headlights, heater blower, rear window defogger, cooling fan, and air conditioner off.Specified CO: 0.1 % max..Β 

    • If unable to obtain this reading; see DTC troubleshooting .
    • If unable to obtain a CO reading of specified % by this procedure, check the tune-up condition.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.