Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Honda Odyssey EXFACTORY OEM SERVICE PROCEDURE
Power Seat Control DTCS
| DTC | Description |
|---|---|
| B1802 | Power seat control unit internal (EEPROM) error |
| B1803 | Power mirror control unit Internal (EEPROM) error |
| B1825 | Slide pulse error (no change in pulse for 1 second) |
| B1826 | Front height pulse error (no change in pulse for 1 second) |
| B1827 | Rear height pulse error (no change in pulse for 1 second) |
| B1828 | Driver seat recline motor pulse error |
| B1829 | AT-P signal and VSP signal mismatch |
| B1836 | Power seat position sensor circuit short |
| B1837 | Memory position calling timeout |
| B1843 | LOCAL communication error |
| B1844 | Power seat slide switch circuit malfunction |
| B1845 | Power seat recline switch circuit malfunction |
| B1846 | Power seat front up-down switch circuit malfunction |
| B1847 | Power seat rear up-down switch circuit malfunction |
| U0199 | Power seat control unit lost communication with door multiplex control unit (DRLockSW frame) |
| U1280 | B-CAN communication bus line error (BUS-OFF) |
| U1281 | Power seat control unit lost communication with MICU (body control module) (MICU frame) |
| DTC | Description |
|---|---|
| U128D | Lost communication with gauge control module (VSP/NE frame) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
