2021 Honda Odyssey EXFACTORY OEM SERVICE PROCEDURE

A/C Signal Circuit Troubleshooting

  1. A/C compressor clutch condition check

    -1. Start the engine, and let it idle.

    -2. Turn the blower switch on.

    -3. Turn the A/C switch on.

    -4. Check the parameter(s) below with the HDS.

    Signal Threshold Current conditions
    Values Unit Values Unit
    A/C CLUTCH ON      

    Do the current condition(s) match the threshold?

    YES 

    Go to step 2.

    NO 

    Do the A/C system test .

  2. A/C system check

    -1. Check the A/C system .

    Does the A/C system operate?

    YES 

    The A/C system circuit is OK.

    NO 

    Go to step 3.

  3. A/C compressor clutch circuit check

    -1. Turn the vehicle to the OFF (LOCK) mode.

    -2. Turn the vehicle to the ON mode.

    -3. Activate the A/C CLUTCH in the Function Test Menu with the HDS.

    A/C CLUTCH

    Is there a clicking noise from the A/C compressor clutch?

    YES 

    The A/C compressor clutch circuit is OK. Do the A/C system test .

    NO 

    Go to step 4.

  4. Open wire check (ACCL line)

    -1. Turn the vehicle to the OFF (LOCK) mode.

    -2. Jump the SCS line with the HDS, and wait more than 1 minute.

    -3. Disconnect the following connector.

    PCM connector A (50P)

    -4. Turn the vehicle to the ON mode.

    -5. Connect terminals A and B with a jumper wire.

    Terminal A PCM connector A (50P) No. 28 
    Terminal B Body ground

    Is there a clicking noise from the A/C compressor clutch?

    YES 

    The ACCL wire is OK. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting, or substitute a known-good PCM , then recheck. If the symptom/indication goes away and the PCM was substituted, replace the original PCM .

    NO 

    Check for poor connections or loose terminals at the power distribution module (A/C compressor clutch relay circuit) and the PCM. If the connections and terminals are OK, check the power distribution module. If needed, repair an open in the ACCL wire between the PCM (A28) and the power distribution module, or other parts in the A/C systems.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.