2021 Honda Odyssey EX-LFACTORY OEM SERVICE PROCEDURE

Idle Speed Inspection: Inspection

NOTE: 

  • Before checking the idle speed, check these items:
    • The malfunction indicator lamp (MIL) has not been reported on, and there are no DTCs.
    • Spark plugs
    • Air cleaner
    • PCV system
  • Apply the parking brake.
  1. HDS - Connect 
  2. Idle Speed - Inspect
    1. Start the engine. Warm up the engine by raising the engine speed around 3, 000 rpm until the cooling fan comes on, then let it idle.

    2. Check the idle speed under no load conditions: headlights, blower fan, radiator fan, audio system, and air conditioner off.

    Idle speed should be: 680 +/- 50 rpm (in P or N) 

    3. Let the engine idle for 1 minute with high electric load (A/C on, temperature set to max cool, blower fan on high, headlights on high beam).

    Idle speed should be: 680 +/- 50 rpm (in P or N) 


    NOTE:  If the idle speed is not within specification, do the PCM idle learn procedure . If the idle speed is still not within specification, go to the symptom troubleshooting .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.