Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Honda Insight EXFACTORY OEM SERVICE PROCEDURE
Malfunction Threshold
Either of these conditions is met:
- When the leak check pressure sensor output does not change under the state of fuel vapor containment valve close stuck, it is judged as normal.
- When the change in the fuel tank internal pressure is -0.37 kPa (-0.11 inHg, -2.8 mmHg) or less even after 60 seconds, a malfunction is identified.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.