Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Honda HR-V LX, FWDFACTORY OEM SERVICE PROCEDURE
Valve Inspection: Inspection
- Valve - Remove
- Valve - Inspect
1. Measure the valve in these areas. Intake Valve Dimensions
Exhaust Valve Dimensions
A Standard (New): 115.65-116.25 mm (4.5531-4.5768 in) B Standard (New): 25.85-26.15 mm (1.0177-1.0295 in) C Standard (New): 5.45-5.46 mm (0.2146-0.2150 in) C Service Limit: 5.42 mm (0.2134 in) A Standard (New): 117.50-118.10 mm (4.6260-4.6496 in) B Standard (New): 32.85-33.15 mm (1.2933-1.3051 in) C Standard (New): 5.48-5.49 mm (0.2157-0.2161 in) C Service Limit: 5.45 mm (0.2146 in) - All Removed Parts - Install
1. Install the parts in the reverse order of removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
