WARNING: This page is about a different car, the 2015 Lincoln MKZ. However, it is still accessible from the selected car via links, so may be relevant.

The chart describes specific module configuration information:

Module Name	Programmable Module Installation (PMI) Available	Reprogram/Flash Capable	Requires Adaptive Learning or Calibration	Available Programmable Parameters
ACCM	No	No	No	None
APIM	Yes	Yes	No	None
ABS module	Yes	Yes	ABS bleed (HEV) Multi-calibration routine (HEV) Inlet valve calibration (HEV) Master cylinder isolation calibration (HEV) IVD initialization EPB apply and release	None
ACM	Yes	Yes	No	None
BECM	Yes	Yes	No	None
BCM	Yes	Yes	Ambient lighting calibration Rear view camera calibration	DRL configuration Keyless entry/passive start enable/disable Remote start enable/disable Trim switch enable/disable
CCM	Yes	Yes	No	None
DSP	Yes	Yes	No	None
DACMC (Integrated with ACM except for China THX® audio system)	Yes	Yes	No	None
DC/ DC Converter Control Module (DC/DC) (HEV)	No	No	No	None
DDM	Yes	Yes	No	None
DSM	Yes	Yes	No	None
SCME	Yes	Yes	No	None
SCMG	Yes	Yes	No	None
FCIM	Yes	Yes	No	None
GWM	Yes	Yes	No	None
GSM	Yes	Yes	No	None
GFM (CD player)	No	No	No	None
GPSM	Yes	Yes	No	None
Headlamp Control Module (HCM)	Yes	Yes	No	None
HUD module	No	No	No	None
IPC	Yes	Yes	No	Automatic engine ignition shutdown (AEIS) with override Daytime running lamps (DRL) control function Driver Beltminder Mid-passenger Beltminder Passenger Beltminder Remote start enable/disable climate settings driver seat passenger seat rear defrost steering wheel
HSWM	No	No	No	None
IPMA module	Yes	Yes	Camera calibration	None
OCSM	No	No	OCSM re-zero	None
PAM (integrated with BCM)	Yes	Yes	No	None
SCMH	Yes	Yes	No	None
PSCM	Yes	Yes	No	None
PCM	No	Yes	No	None
PDM	Yes	Yes	No	None
RTM	Yes	Yes	No	None
RACM (China only)	No	No	No	None
RGTM	Yes	Yes	Power Luggage Compartment Lid Initialization	None
RCM	Yes	Yes	No	None
SODL	Yes	Yes	No	Blockage enabled Enable/disable configuration
SODR	Yes	Yes	No	Blockage enabled Enable/disable configuration
SCCM	Yes	Yes	No	None
SOBDMC/ TCM (HEV)	Yes	Yes	No	None
TCU	Yes	Yes	No	None
TRCM	Yes	Yes	No	None
VDM	Yes	Yes	Suspension height sensor calibration	None

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Module Configuration and Parameter Chart

Use the Manual With the Right Hardware

When to See a Mechanic