Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Honda Odyssey EXFACTORY OEM SERVICE PROCEDURE
DTC P0602: PCM Programming Error
NOTE:
- Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION ).
- This DTC is indicated when a PCM update is not completed.
- Do not turn the ignition switch to ACC (I) or LOCK (0) while updating the PCM. If you do, the PCM can be damaged.
- Update the PCM (see PCM UPDATE ).
- Check for Pending or Confirmed DTCs with the HDS.
Is DTC P0602 indicated?
YES -Replace the original PCM (see PCM REPLACEMENT ).
NO -The troubleshooting is complete.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.